
Robustel GoRugged R3000 User Guide
RT_UG_R3000_v.2.0.0 17.01.2014 56 / 131
Confidential
Available when enable Pulse in Alarm On Action/Alarm Off Action.
Input from 0 to 30000ms. (0=generate pulse without delay)
Available when enable Pulse in Alarm On Action/Alarm Off Action.
In Pulse Output mode, the selected digital output channel will generate a square
wave as specified in the pulse mode parameters. The low level widths are specified
here.
Input from 1 to 30000 ms.
Available when enable Pulse in Alarm On Action/Alarm Off Action.
In Pulse Output mode, the selected digital output channel will generate a square
wave as specified in the pulse mode parameters. The high level widths are
specified here.
Input from 1 to 30000 ms.
Available when enable Pulse in Alarm On Action/Alarm Off Action.
The number of pulses, input from 0 to 30000. (0 for continuous pulse output)
Available when enable SMS Control in Alarm Source.
Input the SMS content to e (70 ASIC II char max).
Available when enable SMS Control in Alarm Source.
Input the SMS content, which will be sent after DO was triggered. (70 ASIC II char
max).
Input the SMS content, which will be sent after DO was recovered. (70 ASIC II char
max).
Click to add phone groups.
Note: R3000-4L does not support SMS/Call function, so Call and SMS section will not be displayed on the web page.
3.16 Configuration -> USB
This section allows users to set the USB parameters.
Note: Users can insert an USB storage device, such as U disk and hard disk, into the router’s USB interface. If there is
configuration file or firmware of R3000 inside the USB storage devices, R3000 will automatically update the
configuration file or firmware. We will provide another file to show how to do USB automatic update.
Komentáře k této Příručce